The holder "feet" provide approximately 1" of rubberized support, which may not suit gear with a rounded lip of similar height for angled setups.

It's recommended to use four to five tiers for flexibility in expanding synth collections, while six tiers are considered overkill for most users.

Owners recommend sketching out equipment placement before assembly to avoid the difficulty of reconfiguring the stand once set up.

Owners note efficient use of space with Jaspers stands, often incorporating vinyl crates or additional storage below the lowest tier.

Owners find the top four tiers easily accessible, recommending keeping favorite or frequently used instruments away from the lowest tier to avoid discomfort.

Users suggest placing less frequently used gear on the bottom tier for ease of access, especially if you are shorter in stature.

Owners can play synths on upper tiers comfortably by raising their arms slightly; MIDI is often used for complex parts on these tiers.

Angling the Jaspers stand allows access behind the setup, though this increases its visual bulk compared to more compact, non-A-frame stands.

The stand's configuration flexibility allows it to accommodate a variety of gear setups, with the potential to reconfigure if needed.

The stand is praised for allowing users to stand while playing, potentially reducing sitting time during long sessions.

The stand accommodates a Yamaha CP-20 weighing 89.3 lbs without issue, but a Fender Rhodes 73 would be too heavy due to its additional 40 lbs.

The 5D-120B model is praised for its ability to fit 61-key synths comfortably, with room for multiple small synths or modules on each row.

The Jaspers 5D-120B stand can be customized with additional brackets including 40cm and 60cm brackets, and a laptop bracket for pedals.

The stand can accommodate two 22" 37-key synths side by side, but a 37-key synth cannot fit next to a Take 5 due to width constraints.

Users note that the Jaspers 5D-120B is stable even with heavy synths but can wobble slightly; tightening bolts on arms is advised to minimize this.

Excellent construction with stability reported even under synths weighing around 20 lbs; recommended longer arms and bracing for heavier synths over 15 kg.

Users have utilized wood pieces to extend bracket length across tiers, offering a cost-saving alternative to purchasing additional brackets.

Total cost can reach around 500 euros with additional holders, while the stand itself is approximately 300 euros.